Under Sink Drinking Water Filter Kit (With 3M AP2-C405-SG Rated Filter) FULL DIY System
The 3M AP2-C405-SG cartridge is tested and certified by NSF International to meet or exceed NSF/ANSI Standards 42 & 53
You are buying the whole system, which includes:
Tap of your choice.
Saddle valve for connection to mains piping.**
1 x Tap reducer fitting for ¼ inch pipe connection.
3 Meters of ¼ inch water pipe (white).
1 x 3M/Cuno AP2-C405-SG Water Filter.
1x 3M AP2 head.
Set of easy to follow installation instructions.
1.9 Litres Per Minute / 0.5 Gallons Per Minute
Minimum: 25 psi / 1.7 bar
Maximum: 120 psi / 8.2 bar
Minimum: 4.4°C / 40°F
Maximum: 37.7°C / 100°F
Taps Approximate Dimensions
Tap Dimensions may vary depending upon selection, please contact us if unsure.
Height from surface to top of tap
Stem Through Surface
The taps have a 70mm stem and although designed to fit onto your sink, should fit through most modern-day worktop and kitchen sink tops.
The hole you will be required to drill through your work-surface should be between 11mm – 16mm
Tap Operating Pressure
Min: 0.5 Bar / 7.5 psi
Max: 8.5 Bar / 123 psi
**Please note that the Saddle Valve mains water connection fitting is only suitable for standard copper mains water pipe. If you have plastic piping then you will require a John Guest ASV3 15mm Plastic Pipe Fitting which can be found in the “You May Also Like” section at the bottom of this page.
If you are unsure that this is the right part for you then please call us on 01704 807600 and we will gladly advise you on alternative options.
This is a DIY installation system, however it is strongly advised that the fitter should have a general knowledge of practical plumbing.
If in any doubt please consult a plumber.
Finerfilters Ltd. cannot take responsibility for damage caused by user error.